Bc-technologies A-Computer Programming (HE Series) Manual do Utilizador descarregar pdf (Página 15)

Cycle Segment Charts (continued)

Programming

Details

Use Up or Down to change. Start key is enter or advance

00 or 02-30 Segment time: 00 to skip, or any time between 0 and 30 minutes

HFIL CFIL BFIL Fill temperature: Hot, Cold, or Warm (both fill)

LOLE, nDle or HILE Select Fill level, Low, Med or High

SUP0 - SUP7 Select Supply 0-7 (0 for no supply during the step)

00, 75 - 200

00,25-93

SPIN flases for 1 sec

TIME flases for 1 sec

00 or 30-120

Select time for spin: 30 - 120 seconds. 00 for no spin.

Wash Segment

Note: Supply 4 and 7 are only availble if enabled in Setup

Note: Heat is only available if enabled in Setup

Display

UASH

Enter temperature: 75-200 deg F, 25-93 deg C. 00 for no heat.

Select 00 if you have programmed a Flushing Prewash

Details

Use Up or Down to change. Start key is enter or advance

drin or srin (1) Select Rinse Method: Dilution Rinse or Spray Rinse

00 or 02-30 (2) Segment time: 00 to skip, or any time between 0 and 30 min

HFIL CFIL BFIL (3) Fill temperature: Hot, Cold, or Warm (both fill)

LOLE, nDle or HILE (4) Select Fill level, Low, Med or High

SUP0 - SUP7 (5) Select Supply 0-7 (0 for no supply during the step)

00, 75 - 200

00, 25 - 93

SPIN flases for 1 sec

TIME flases for 1 sec

00 or 30 - 120

(7) Select time for spin: 30 - 120 seconds. 00 for no spin.

Note: Heat is only available if enabled in Setup

Fill Segments (Fill 1 through Fill 5)

Display

fil1 fil2 fil3 fil4 fil5

(6) Enter temperature: 75-200 deg F, 25-93 deg C. 00 for no

heat. Select 00 if you have programmed a Flushing Prewash

Note: Supply 4 and 7 are only availble if enabled in Setup

Note: If Spray Rinse is selected for the segment, steps 3 to 6 are skipped.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Sem comentários

Bc-technologies A-Computer Programming (HE Series) Manual do Utilizador Página 15